Dialogic® Vision™ CX Video Gateway Administration Manual
Managing the CX Video Gateway
Step
Action
4
To add a CCXML application as a custom application, click
New
at the bottom of the Custom
section, and enter the following information:
Field
Description
Number
Number range associated with the CCXML application specified by the
range
Initial URI value. The number range can be a combination of numbers,
alphabetic characters, and wildcards.
The gateway checks if the dialed number of an incoming call matches this.
If it finds a match, the corresponding CCXML application is executed.
If the dialed number matches the number range of multiple applications,
the call is matched to the most specific number range.
For more information, see
CCXML application definition pattern matching
syntax
on page 91.
Initial URI
Initial URI to use for an incoming all, based on the number range of the
dialed number.
Dialog
List of dialog servers for the application. Separate each dialog server with
servers
a comma.
Outbound
List of outbound routes for the calls that the CCXML application creates.
routes
Separate each route with a comma.
PSTN routes
For a PSTN route, the syntax is:
route-
Route_Number
[
Priority
]
where:
•
Route_Number
identifies a PSTN route, as defined in the
telecom
conf
file.
•
Priority
specifies the priority level for load balancing over the
telecom routes.
If
Route_Number
is set to 0, the route is chosen automatically according
to the associated incoming call.
SIP routes
For a SIP route, the syntax is:
IP_Address
:
Port
[
Priority
]
where:
•
IP_Address
:
Port
is the IP address and port of a SIP route.
•
Priority
the priority level for load balancing over SIP routes.
For both PSTN and SIP routes,
Priority
is optional, and its value is
relative from 0 (default) to any required level. The highest priority is
expressed by the lowest value (typically 0). Load balancing is performed
between routes with the same priority and starts by routes defined with
the highest priority.
Note:
If you have outbound PSTN routes defined in the CCXML
application, the CX Video Gateway processes those routes before it
processes the routes defined here.
For information about creating call routes for custom CCXML applications, see
Fine tuning
gateway routing
on page 126.
Dialogic
89
