#LiveYourRide
2.4.6
LIGHTS
In all FLUSSO models there is a rear light integrated in the seatpost. It is also
advisable to affix reflectors (not supplied) after consulting the national and
regional regulations of the relevant country of use.
Once the pedal assistance system has been switched on (see next paragraph),
the rear light is activated by pressing the power button on the Maxon
controller again.
Pressing the power button again turns the rear light off.
2.4.7
PEDAL ASSISTANCE SYSTEM
All FLUSSO models are equipped with MAXON electric engine for assistance
to the user during pedalling. Once the assistance intensity of the electric
engine has been selected, the engine activates autonomously while the
pedals are being operated, and is deactivated immediately if the pedalling
stops. The power of the engine depends on the torque imparted to the
pedals, according to a multiplicative factor according to the level of assistance
selected. The assistance drops linearly until it cancels out when it reaches 25
km/h.
2.4.4
BRAKES
All FLUSSO assemblies are equipped with a disc braking system that can
be operated using the levers on the SRAM controls. The right lever activates
the rear brake, the left lever activates the front brake. The braking torque
is proportional to the force applied to the levers. It is possible to adjust the
inclination and positioning of the levers by loosening the relative locking
screw. Before using the pedal-assisted bicycle, make sure that you have
tightened the fixing screws of the brake levers according to the torque
indicated on the screws and/or on the documentation available on the
website
https://www.sram.com/en/sram.
It is not recommended to
adjust any other parameter of the braking system. If in doubt about the
adjustment, consult an authorised dealer. Do not touch the brake discs after
braking, they may be hot and cause burns.
2.4.5
PEDALS
The pedals must be tightened to the cranks. By applying torque to the pedals,
it is possible to impose a translational motion on the pedal-assisted bicycle.
All FLUSSO models are equipped with electric pedal assistance, the engine is
automatically activated once the pedal-assisted bicycle is switched on and a
torque is applied to the pedals. The user can mount and dismount the pedals
making sure that they are tightened to a torque between 22 and 25 Nm.
When mounting, pay attention to the direction of screwing the pedals: the
right pedal has a right-hand thread, the left pedal has a left-hand thread.
The pedals are not supplied, it is recommended to assemble a model in
accordance with the laws in force in the country of use.
10
11
