MODEL BMGP-600 GRINDER
SECTION 7
MAINTENANCE
49
Grinding & Polishing
OPERATING MANUAL
DECEMBER 2008
As previously mentioned in Section 5.1 Initial operation, we recommend
conducting initial repair work on the machine with the support of Diamatic
personnel, by taking this advice, maintenance personnel get the opportunity to
be trained by an expert on the machine.
If parts or components are to be replaced, the following sequence of
maintenance must be followed.
It is advisable to stock all spare or wear parts that cannot be obtained quickly.
As a rule, production standstill periods are more expensive than the cost for
carrying the corresponding spare part.
Screws or bolts that have been removed must be replaced with those of the
same quality (strength, material) and design.
7.3 REPAIRING
Prior to any repair work on the machine and its drives, secure
the machine against unintentional activation. See Section 2.6.
Use of non-original replacement components or wear parts may
void the machine warranty
.
