AIRCRAFT
DA 40 Series AMM
Temporary Revision
NLG Inspection & Maintenance
Detail Steps/Work Items
Key Items
6.
Examine the tires. Look specially for cuts in the
side walls.
Refer to Section 32-40.
7.
Examine the wheel rims. Look specially for
deformation of the flanges.
8.
Examine the brake discs. Look specially for
damage. Turn the wheel and make sure the disc
is not bent.
9.
Examine the nose-gear assembly. Look specially
for:
Deformation of the upper cross bar of the
engine mount.
Nose wheel strut axle area.
Remove the fork assembly. (Refer to Section
32-20.) Use a flashlight and a 10X magnifier.
Pay special attention to the pivot axle
(especially the radius at the top, filleted areas,
and the threads at the bottom of the fork pivot
axle). If cracks are suspected, perform NDT.
Install the fork assembly. Refer to Section 32-
20.
CAUTION:
IF YOU THINK THE AIRPLANE HAS DAMAGE TO AN AREA THAT
TRANSMITS A LOAD, YOU MUST ASK THE AIRPLANE
MANUFACTURER FOR ADVICE.
Doc # 6.02.01
AMM-TR-MÄM 40-1037
05-50-00
Page 10
13 Jul 2020
