OPERATING
Vacuum Attachment Plate Thumbscrews
3. Press the anti-rotation pin down, located on
the front frame base, while spinning the
blade shaft by hand until the pin engages
the slot in the shaft preventing it from
rotating.
Anti-Rotation Pin
4. While holding the anti-rotation pin down,
remove the blade shaft nut by turning it
counterclockwise to loosen.
5. Carefully pull the outer flange off of the
blade shaft.
Removing the Outer Flange
6. Inspect the nut, outer flange, and inner
flange for damages and clean, repair, or
replace as necessary.
7. Inspect the blade for damages. DO NOT
use blades that are too large or too small
for the saw.
8. Fit the blade onto the blade shaft and place
it against the inner blade flange (the blade
should fit snug on the blade shaft). Always
point the arrow printed on the blade in the
direction of the blade shaft’s rotation.
9. Fit the outer flange onto the blade shaft
and place it against the blade.
Inserting the Outer Flange
10. Place the blade shaft nut onto the end of
the blade shaft and tighten the nut by hand.
11. Press the anti-rotation pin down, located on
the front frame base, while spinning the
blade shaft by hand until the pin engages
the slot in the shaft preventing it from
rotating.
Tightening the Nut
12. While holding the anti-rotation pin down,
tighten the nut to 50 ft-lb (67.8 Nm) to
properly secure the outer flange and blade.
This measurement can be verified with a
torque wrench.
13. Raise the saw off the ground and replace
the skid plate weldment and reinsert the pin
to secure.
14. Replace the vacuum attachment plate and
tighten the thumbscrews to secure.
18
Summary of Contents for CC125BXL-EE6
Page 2: ......
Page 43: ...REFERENCES ...
