MAINTENANCE
Service Schedule
The service schedule is based primarily on the standard operating time of the machine. The
frequency of the maintenance tasks can be increased based on the working environments of the
machine. Refer to the individual manufacturers manuals for additional maintenance requirements.
Task
Cycle
Daily
100 Hrs.
Yearly
Visually inspect saw for damage and repair as necessary
X
Wipe down and clean all components for dust, debris, and slurry
X
Check that all safety guards are in place and in good operating
condition
X
Inspect the skid plate for damages and clean, repair, or replace as
necessary.
X
Check for loose or frayed wiring. Repair/replace as necessary
X
Check for loose nuts and bolts and retighten
X
Check engine oil level
X
Check fuel level
X
Check air filter
X
Lubricate blade shaft bearings (End of work day)
X
Inspect all belts for tension or wear and re-tension or replace as
necessary
X
1
Clean air filter
X
2-3
Replace engine oil
X
4
Clean sediment cup
X
Check and adjust spark plug
X
Clean spark arrester
X
5
Replace air filter
X
Replace spark plug
X
1 - Initially inspect the belt after the first four hours and then daily.
2 - Change every 25 hours on Vanguard engine.
3 - Service more often as required
4 - Replace every 50 hours in Vanguard engine
5 - Clean every 50 hour on Vanguard engine
27
Summary of Contents for CC125BXL-EE6
Page 2: ......
Page 43: ...REFERENCES ...
