OPERATING
Blade Lowering Speed (Optional)
Turn the
Blade Lowering Speed
valve
counterclockwise to increase the blade’s
lowering speed and clockwise to decrease the
blade’s lowering speed.
Note: The valve does not adjust the blade’s
raising speed
.
Blade Lowering Speed Valve
Spotlight (Optional)
1. Loosen both spotlight bar lock knobs and
slide the bar from side to side to adjust the
length of the bar.
Spotlight and lock knobs
2. Tighten the lock knobs to secure.
3. Turn the spotlight switch
ON
or
OFF
as
needed for additional lighting.
Fuel System
WARNING
•
Always use caution when refueling.
•
DO NOT operate the saw with a fuel
leak.
•
DO NOT fuel the saw with
the engine running.
•
DO NOT smoke or expose
fuel to open flames when filling the fuel
tank or working with fuel.
CAUTION
•
Clean up any spilled fuel prior to
starting the engine.
•
Fuel may seep out from the fuel cap
vent (applicable models) when raising
the saw if the fuel tank is overfilled.
Adding Fuel
1. Lower the saw to level the frame.
2. Turn the ignition switch to
OFF
and let the
engine cool down.
3. Remove the fuel tank cap.
4. Fill the fuel tank using unleaded gasoline
with a minimum of 87 octane. DO NOT
overfill the tank for expansion purposes.
Refer to the engine manual for additional
information on appropriate fuels in normal
and cold weather temperatures.
5. Replace the fuel tank cap and secure.
Blade Guard
WARNING
DO NOT operate the saw with the blade guard
raised or removed.
DO NOT remove the blade guard with the
engine running.
Blade exposure should not exceed 180° while
cutting.
Always pivot the front of the blade
guard 180° (fully upward) so the
guard does not swing down
unexpectedly, which may cause serious
injuries.
Always secure the pivoted section of the blade
guard using the detent pin (guards 26” and
up).
When pivoting the front of the blade guard,
raise/lower it cautiously and slowly to avoid
serious injuries.
The blade guard shields the blade and must
always be in place when operating the saw.
Blade guards generally stay in place at all
times, except for when changing to another
guard size or when using the guard on the
opposite side of the saw. Regularly inspect the
blade guard and water tubes. Clean, repair, or
replace dirty or damaged components
immediately.
Note: Always use a guard size that matches
the blade size. Refer to the CC3500J Parts List
for additional information
.
16
Summary of Contents for CC3538JK Series
