MAINTENANCE
Maintenance
General
Failure to read and comply with the
maintenance instructions provided in this
manual prior to performing maintenance may
result in serious injuries and/or death, and may
harm the saw. DO NOT attempt to perform
maintenance on the saw if you are not properly
trained for it, or are not supervised by an
experienced person.
Refer to the CC3500J Parts List for additional
information and part diagrams when
performing maintenance tasks. Refer to the
engine manufacturer as the primary source for
all safety, operations, and maintenance
instructions for the engine. Contact the saw
and/or engine manufacturer with any additional
questions.
Remove all necessary guards and access
panels prior to servicing the saw. Replace prior
to operating.
Pre Maintenance Preparations
•
Ensure the saw is in a safe area to conduct
maintenance.
•
Maintain proper cleanliness of the work
area to minimize personnel injury or
equipment damage.
•
Ensure the saw is sufficiently cool to
conduct any maintenance.
•
Remove the cutting blade prior to starting
any maintenance.
•
Ensure there is adequate lighting in the
work area to ensure safety.
•
Ensure all equipment and tools required for
the maintenance task are staged and
available for use.
•
Prior to any maintenance being performed,
know the locations of all safety equipment
such as fire extinguishers, first aid kits, etc.
•
All maintenance shall be performed by
qualified personnel only.
Rear Cover Screen
The rear cover screen is a versatile component
in regards to maintenance of the machine. It
can be removed to gain access to components
within the upright assembly.
General Cleaning
The saw must be cleaned after each use and
prior to conducting any maintenance. Ensure
that the saw is cool prior to cleaning. Ensure
affected electrical equipment is properly
covered or de-energized prior to cleaning with
water or air.
Cleaning Techniques
Various cleaning options can be utilized
depending on the type of cleaning required.
High pressure washers and a mild detergent
will work the best. Compressed air and low
pressure water can also be utilized where
required.
CAUTION
Care must be taken when using high
pressure water and compressed air to
conduct any maintenance or cleaning.
High pressure water and compressed air
can cause injury to personnel or damage
to equipment if not used properly.
Engine
Use a mild detergent and water to clean the
engine. Do not to spray water forcefully on the
engine to prevent damage to components.
25
Summary of Contents for CC3538JK Series
