MAINTENANCE
Daily Service
Check Engine Oil Level
Prior to checking the engine oil level, ensure
that there is no blade installed on the saw and
the saw frame that is in a level position.
1. Remove the engine oil dipstick from the
right side of the engine.
Engine Oil Dipstick
2. Check the oil level on the dipstick. The
level should be between the Full and
Low marks in the knurled section.
Engine Oil Level Indicators
3. If the level is low, remove the engine oil fill
cap located on the front of the engine.
Engine Oil Fill Cap
4. Add oil until the level is correct.
5. Replace the engine oil fill cap.
Check Fuel Level
Prior to checking the fuel level, ensure
that there is no blade installed on the
saw and that the saw frame is in a
level position.
1. Visually check the fuel level from the fuel
filler cap located on the left side of the
control panel.
2. If fuel level is low, remove the fuel tank fill
cap.
Fuel Tank Fill Cap
3. Fill the tank with unleaded fuel only.
Note: Lower ethanol fuel is strongly
recommended, particularly for summer
months.
Hydraulic System
WARNING
•
Always place a piece of
cardboard or paper up
against hydraulic
components, or use a leak detection fluid
to check for hydraulic fluid leaks. Keep
all body parts away from leaks and/or
areas that may eject hydraulic fluid.
Pressurized hydraulic fluid can penetrate
the skin, causing serious injuries. Seek
medical attention immediately!
•
Always make sure any hydraulic
components being serviced are not
supporting the weight of other saw
components. If a particular component is
under pressure when connections points
are loosened, oil may spray out
forcefully.
28
Summary of Contents for CC3538JK Series
