MAINTENANCE
Inspect all hydraulic hoses and fittings daily for
leaks. Remember to use cardboard or a piece
of paper when checking for leaks and replace
damaged components immediately.
Adding Fluid to the Hydraulic Lift Pump
Check the fluid daily and add fluid to the pump
as necessary.
1. Lower the saw to level the frame.
2. Remove the hydraulic pump cover plate.
Hydraulic Pump Cover Plate
3. Remove the hydraulic pump breather cap.
Hydraulic Lift Pump Breather Cap
4. Using a funnel add Dexron 3 automatic
transmission fluid or equivalent to just
below where the fill port extends into the
hydraulic pump. Do not overfill, as this will
cause oil leakage through the breather cap
when raising the saw.
5. Replace the breather cap and retighten to
secure.
6. Replace the hydraulic pump cover plate.
Lubricate the Blade Shaft Bearings
At the end of each work day, lubricate the two
front blade shaft bearings.
1. Locate the right and left blade shaft bearing
grease fittings located on the bearing
lubrication manifold located at the front of
the saw.
Right and Left Blade Shaft Bearing Grease Fittings
2. Add no more than two pumps of bearing
grease into each of the two blade shaft
bearing grease fittings.
Belt System
WARNING
•
Turn the engine off prior to
servicing the belts
•
Use extreme caution when working with
belts and rotating machine parts to avoid
entanglement.
CAUTION
Let the belts cool down prior to servicing
them.
29
Summary of Contents for CC3538JK Series
