MAINTENANCE
Lubricate the Front Axle Bearings
1. Raise the saw to the full up position.
Right and Left Front Axle Bearing Grease Fittings
2. Add no more than two pumps of grease to
each of the two front axle bearings grease
fittings located under the frame base on
both the left and right side.
Lubricate the Rear Axle Bearings
1. Lower the saw to the full down position.
Right and Left Rear Axle Bearing Grease Fittings
2. Add no more than two pumps of grease to
each of the two rear axle bearings grease
fittings located under the frame base on
both the left and right side.
Lubricate the Transmission Jackshaft
Bearings
1. Using a 3/8” socket remove the rear cover
screen from the back of the upright
assembly.
2. Using a 7/16” socket remove the gear
guard from the transmission platform
weldment.
Gear Guard
3. Locate the two transmission jackshaft
bearing fittings and add no more than two
pumps of grease to each of the bearings
grease fittings.
4. Reinstall the gear guard and tighten the
1/4"-20 bolts to secure.
5. Reinstall the rear cover screen and tighten
the 1/4”-20 bolts to secure.
Lubricate the Linkage Assembly
The linkage assembly is a part of the rear drive
assembly. There are three linkages that
contain two rod ends each that must be
lubricated. Two of the linkages can be
accessed from the back of the saw and the
third can be accessed from the right side of the
saw.
1. Using a 3/8” socket remove the rear cover
screen from the back of the upright
assembly.
2. Locate the 10-1/2” linkage running parallel
to the frame base and add no more than
one pump of grease into each of the two
rod ends.
Rear Drive Linkage, 10-1/2”
32
Summary of Contents for CC3538JK Series
