MAINTENANCE
3. Locate the 7-3/4” linkage that connects the
control lever assembly to the rear drive
assembly and add no more than one pump
of grease to each of the two rod ends.
Control Lever Linkage
4. From the left side of the saw just behind
the engine, locate the 7-3/4” linkage
running parallel to the frame base and add
no more than on pump of grease to each of
the two rod ends.
Rear Drive Linkage, 7-3/4”
5. Reinstall the rear cover screen and tighten
the 1/4”-20 bolts to secure.
Lubricate the Front Wheels
1. Raise the saw to the full up position.
2. Locate the grease fitting on the outside of
each front axle wheel and add no more
than two pumps of grease to the wheel
bearings.
Front Wheel Grease Fitting
Replace Engine Oil and Filter
•
Refer to the engine operator’s manual for
oil specifications and capacities.
•
Refer to the engine operator’s manual for
oil filter specifications.
•
Ensure the engine is turned off and
sufficiently cooled down prior to draining
the engine oil.
1. Ensure the saw does not have a blade
attached and is level to the ground.
2. Place a drain pan beneath the drain hose
located on the right side of the saw.
Oil Drain Hose
3. Remove and wipe clean the engine oil
dipstick and set aside.
33
Summary of Contents for CC3538JK Series
