OPERATING
Operating
General Operating Precautions
•
Prior to operating the machine, read the
operator’s manual thoroughly and ensure
that you understand the safe and proper
operation of the machine.
•
Use approved personal protective
equipment at all times while operating the
machine.
•
Ensure that there is firefighting equipment
and a first aid kit nearby while operating the
machine.
•
Ensure the cutting area is free of
obstructions, people, and or animals prior
to operating the machine.
•
Always operate the machine from the
operator’s position at the rear of the
machine between the handlebars.
•
Do not stand in front or behind the blade
path while the engine is running.
Emergency Stop
If an emergency condition should arise, the
machine is equipped with an emergency stop
button located on the top of the control panel.
The emergency stop places the machine into
safe mode allowing the operator to address the
emergency condition.
NOTE: Only use the emergency stop in an
emergency condition. Do not use it to stop the
machine during normal operations.
Activating the Emergency Stop
To activate the emergency stop, press down
on the emergency stop button. The engine will
shut off and the display panel will indicate that
the emergency stop is active.
Deactivating the Emergency Stop
Prior to deactivating the emergency stop,
ensure that the machine is back into a safe
operating condition. Then turn the emergency
stop button clockwise until it springs back into
position. The machine can now be restarted.
Emergency Stop
Handlebars
The handlebars help to guide and maneuver
the saw. During transporting of the saw, the
handlebars should be placed in the storage
tubes to save on space and prevent losing
them. Place the handlebars in the desired
position for better leverage when steering. To
maneuver the saw forward or backward, turn
on the
Free Wheel
switch and move the saw
as desired.
NOTE: The free wheel component only works
with the ignition key at
ON position
.
Handlebar Storage
26
Summary of Contents for CC5049D
