OPERATING
Blade Lowering Speed Valve
Moving the Machine Forward / Reverse with
the Engine Running
NOTE: Prior to moving the machine, read and
understand the “Starting the engine and
Stopping the engine” section of this manual.
The speed control lever will only move the saw
in a forward or reverse direction when the
engine is running.
1. Turn the ignition switch to the
ON
position.
2. On the display panel, verify the blade size
and then open the main screen.
3. Raise the machine by pressing the
Raise
(Left) pushbutton on the control grip until
the blade clears the pavement.
4. Place the speed control lever in the
STOP
position.
5. Turn the ignition switch to the
START
position until the engine starts, then release
the switch. The key will return to the
ON
position.
6. Take the speed control lever out of the
STOP
position and slowly push it forward
to move the machine forward, or to the rear
to move the machine in reverse.
NOTE:
The machine’s travel speed will
increase as the lever is moved farther in
either the forward or reverse direction.
7. To stop the forward or reverse motion,
place the speed control lever in the mid-
position and/or into the
STOP
position.
Moving the Machine with the Engine Off
1. Turn the ignition switch to the
ON
position.
2. Raise the machine by pressing the
Raise
(Left) pushbutton on the control grip until
the blade clears the pavement.
3. Place the speed control lever in the
STOP
position.
4. Turn the free wheel switch (located on the
top of the left side control box assembly) to
the
ON
position.
WARNING
Do not turn on the free wheel switch or
attempt to manually push the machine while
it is on a grade or slope. The operator could
lose control of the machine causing serious
injury to the operator or damage to the
machine.
WARNING
Do not tow the machine when the free wheel
switch is on. This could result in damage to
the transmission
5. The machine can now be moved manually
by standing in the operator’s position and
pushing the saw while keeping a firm grip
on the handlebars.
Bogie Wheel (Optional)
An optional bogie wheel can be installed on the
rear of the saw to assist with maneuvering the
saw while it is in the fully raised position. There
are two positions that the wheel will normally
operate in:
•
Locked sideways motion
•
Free wheel motion
Bogie Wheel - Locked Sideways Motion
To lock the wheel for side to side movement:
1. Fully pull the ring on the detent pin.
2. Rotate the pin until the ring is vertical to the
ground.
3. Rotate the wheel to either the right or left
side potion.
4. Release the pin in the locking slot of the pin
assembly.
Bogie Wheel – Locked Sideways Position
28
Summary of Contents for CC5049D
