OPERATING
Bogie Wheel - Free Wheel Motion
To unlock the bogie wheel and allow it to move
freely:
1. Fully pull the ring on the detent pin.
2. Rotate the pin until the ring is horizontal to
the ground.
3. Release the pin in the locked open slot of
the pin assembly.
Bogie Wheel – Locked in Free Motion Position
WARNING
Keep feet clear. When the saw is raised on
any inclined surface, the bogie wheel must
be locked in a perpendicular position
(3 or 9 o’clock) to the rear wheels to prevent
the saw from rolling towards or away from
the operator.
Fuel System
WARNING
Always use caution when refueling.
DO NOT operate the saw with a fuel leak.
DO NOT fuel the saw with the
engine running.
DO NOT smoke or expose fuel to
open flames when filling the fuel
tank or working with fuel.
CAUTION
Clean up any spilled fuel prior to starting the
engine.
Fuel may seep out from the fuel cap vent
(applicable models) when raising the
saw if the fuel tank is overfilled.
Adding Fuel
1. Lower the saw to level the frame.
2. Turn off the engine and let the saw cool
down.
3. Remove the fuel tank cap.
4. Fill the fuel tank with ultra-low sulfur diesel
fuel only. DO NOT overfill the tank for
expansion purposes. Refer to the engine
manual for additional information.
5. Replace the fuel tank cap and secure.
Blade Guard
WARNING
DO NOT operate the saw with the blade
guard raised or removed.
DO NOT remove the blade guard with the
engine running.
Blade exposure should not exceed 180°
while cutting.
Always pivot the front of the blade
guard 180° (fully upward) so the
guard does not swing down
unexpectedly, which may cause serious
injuries.
Always secure the front pivoted section of
the blade guard using the detent pin
(guards 26” and up).
When pivoting the front of the blade guard,
raise/lower it cautiously and slowly to
avoid serious injuries.
The blade guard shields the blade and must
always be in place when operating the saw.
Blade guards generally stay in place at all
times, except for when changing to another
guard size or when using the guard on the
opposite side of the saw. Regularly inspect the
blade guard, the guard mount and water tubes.
Clean, repair, or replace dirty or damaged
components immediately.
NOTE: Always use a guard size that matches
the blade size. Refer to Appendix B.
Installing the Blade Guard
Always install the blade guard with the blade
off the saw.
1. Holding the blade guard handle, face the
front of the blade guard forward and fit the
tapered mount on the side of the guard
onto the tapered mount on the frame.
29
Summary of Contents for CC5049D
