MAINTENANCE
Check and Clean Blade Guard Spray
Tubes
1. Raise the front of the blade guard and pin it
in place using the hinge detent pin if
applicable.
2. Connect a water supply source to the water
manifold on the blade guard.
3. Turn the water supply on and verify that
water is spraying from all spray tube holes.
4. If any clogged holes are detected, shut off
water source and dislodge any debris that
is clogging the hole(s).
5. Turn water on to verify all spray tubes are
clear.
6. Shut off water supply and disconnect from
the water manifold.
7. Pull the detent pin on the blade guard
hinge and lower the front of the guard back
down.
8. Replace detent pin.
Lubricate the Blade Shaft Bearings
At the end of each work day, lubricate the two
front blade shaft bearings. The bearings are
located under the radiator at the front of the
saw.
1. Add no more than two pumps of bearing
grease into each of the two blade shaft
bearing grease fittings.
Grease Fittings – Blade Shaft Bearings
Check Air Cleaner Restriction Indicator
1. Check the restriction indicator located on
the outlet of the air cleaner.
2. If the indicator is red, clean the air cleaner
primary filter in accordance with the
“Cleaning the Outer Primary Filter”
procedure.
Restriction Indicator
3. Ensure the rubber dust ejector boot valve is
clean by pressing inward on both sides of
the ejector boot near the valve opening to
release dust and debris, and clean the
valve opening as necessary.
Rubber Dust Ejector Boot
25 Hour Service
Inspect Belts
Inspect all belts daily for tension or wear.
Re-tension or replace as required in
accordance with the “Blade Drive Belts”
section located in the “Regular Maintenance”
section of this manual.
44
Summary of Contents for CC5049D
