CC7574DKV OPERATOR’S MANUAL
Daily Service
Check Engine Oil Level
Prior to checking the engine oil level, ensure
that there is no blade installed on the saw and
that the saw frame is in a level position.
1. Remove the engine oil dipstick from the left
side of the engine just in front of the oil
filter.
Engine Oil Dipstick
2. Check the oil level on the dipstick. The
level should be between the two round
marks.
Engine Oil Level Indicators
3. If the level is low, remove the engine oil fill
cap located on the left side of the saw just
below and to the rear of the diesel
particulate filter (DPF).
Engine Oil Fill Cap
4. Add oil until the level is correct.
5. Replace the engine oil fill cap.
Check Fuel Level
Prior to checking the fuel level, ensure that
there is no blade installed on the saw and that
the saw frame is in a level position.
1. If fuel level is low, as indicated by the low
fuel level icon on the display panel, remove
the fuel tank fill cap located on the left top
side of the upright assembly.
Fuel Tank Fill Cap
2. Fill the fuel tank with ultra-low sulfur diesel
fuel only.
Hydraulic System
WARNING
Always place a piece of
cardboard or paper up
against hydraulic
components, or use a leak detection fluid
to check for hydraulic fluid leaks. Keep
all body parts away from leaks and/or
areas that may eject hydraulic fluid.
Pressurized hydraulic fluid can penetrate
the skin, causing serious injuries. Seek
medical attention immediately!
Always make sure any hydraulic
components being serviced are not
supporting the weight of other saw
components. If a particular component is
under pressure when connections points
are loosened, oil may spray out
forcefully.
Inspect all hydraulic hoses and fittings daily for
leaks. Remember to use cardboard or a piece
of paper when checking for leaks and replace
damaged components immediately.
43
Summary of Contents for CC7574DKV
