CC7574DKV OPERATOR’S MANUAL
Check and Clean Blade Guard Spray
Tubes
1. Raise the front of the blade guard and pin it
in place using the hinge detent pin (26” and
larger).
2. Connect a water supply source to the water
manifold on the blade guard.
3. Turn the water supply on and verify that
water is spraying from all spray tube holes.
4. If any clogged holes are detected, shut off
water source and dislodge any debris that
is clogging the hole(s).
5. Turn water on to verify all spray tubes are
clear.
6. Shut off water supply and disconnect from
the water manifold.
7. Pull the detent pin on the blade guard
hinge and lower the front of the guard back
down.
8. Replace detent pin.
Check the Air Cleaner Restriction
Indicator
Restriction Indicator
•
Service the air filters when the restriction
indicator turns red.
•
Press the restriction indicator reset button
on the top of the indicator to reset the unit
after the air filters has been serviced.
Rubber Dust Ejector Boot
The rubber dust ejector boot valve ejects
debris and water when operating the saw.
Occasionally inspect and clean the ejector
boot.
•
Press inward on both sides of the ejector
boot near the valve opening to release
debris and water, and clean the valve
opening as necessary.
Rubber Dust Ejector Boot
Draining the Upper Gearbox Heat Sink
(Cold Weather Only)
Upper Gearbox Heat Sink
Drain the heat sink daily during cold weather
operations; especially in freezing weather
conditions.
1. Lower the saw completely.
2. Open the water drain valve on the heat sink
and drain the heat sink completely.
3. Close the water drain valve.
50 Hour Service
Drain the Fuel/Water Separator Filter
Inspect the fuel/water separator and drain as
necessary. The unit is located on the left side
of the saw attached to the inside of the lift
frame.
1. Unlatch and open the left side door.
45
Summary of Contents for CC7574DKV
