CC7574DKV OPERATOR’S MANUAL
Belt Tension Bolt
7. Remove both sets of belts from the four
sheaves.
8. Loop and align the first matched set of
belts around the lower gearbox sheave and
then around the upper gearbox sheave,
and repeat with the second matched set of
belts. Repeat the procedure for the second
set of sheaves.
Note: Make sure the belts are fitted against
each other, and are aligned on the sheaves.
9. Turn both blade drive tension bolts (large
threaded bolt on engine foot) clockwise
equally to tighten the belts. Test the belt
tension and readjust the bolts as
necessary. DO NOT exceed the
manufacturer’s tension settings.
10. Tighten the nut on both blade drive belt
tension bolts down to the engine foot.
11. Retighten the two engine cradle screws.
12. Close and latch the front hood assembly.
Engine
WARNING
•
Let the engine cool down prior to
servicing the saw.
•
DO NOT service the saw with the engine
running unless otherwise stated.
Refer to the engine manual and
manufacturer for a full engine maintenance
schedule and additional engine
maintenance information.
Cleaning the Engine
Clean and wipe down the engine’s exterior,
fans, and guards daily to prevent high
operating temperatures.
Storing
Complete the tasks listed below prior to storing
the saw for longer time frames:
•
Drain the water lines/hoses.
•
Turn off all switches and controls.
•
Lower the saw completely to remove strain
on the lifting mechanism.
•
Clean and wipe down the saw to remove
dust, debris, and slurry from saw
components (especially fans).
•
Remove the battery and store in a proper
location, out of reach from children
•
Refer to the engine manual for all engine
and fuel recommendations prior to storing.
•
Store the saw in a dry area, protected from
outdoor elements and out of reach from
children.
•
Refer to the engine manual for all engine
and fuel recommendations prior to storing.
•
Store the saw in a dry area, protected from
outdoor elements and out of reach from
children.
Disposal
Dispose of the saw when it’s no longer
repairable, and/or contains safety hazards not
worth repairing or maintaining. Complete the
tasks listed below when discontinuing usage:
•
Drain all fluids and dispose of according to
city, state, and federal regulations.
•
Remove the battery and bring to a recycling
facility; many battery retailers also accept
old batteries.
•
Transport the saw to a salvage yard or
recycling facility.
Engine Regeneration
The engine is installed with a Diesel Particulate
Filter (DPF). A DPF is a device designed to
remove diesel particulate matter or soot from
the exhaust gas of the diesel engine. This
removal process is called a regeneration.
There are two types of regeneration associated
with the engine:
•
Active
•
Parked
60
Summary of Contents for CC7574DKV
