Elton User Manual Rev 1.04
Page 21
8. CONNECTOR PINOUT SPECIFICATIONS
Power IN Connector: J16
The Power-IN connector supplies power using an input voltage range from +9V to +20V.
NOTE
: The AGX Xavier Series Module is not hot-pluggable. Before installing or removing the module, the
main power supply pins must be disconnected and the recommended wait-time of 1-minute must
be allowed for the various power rails to fully discharge.
The pinouts for the Power-IN connector are specified below.
VIN
1
2
GND
VIN
3
4
GND
Connector Type:
2x2 Samtec IPL1
Mating Cable Part Number:
6981507
RTC Battery Connector: J8
The RTC (Real Time Clock) battery provides power and maintains the internal real-time clock and calendar
functions in the system.
The pinouts for the RTC Battery connector are specified below.
RTC_BATT
1
GND
2
Connector Type:
2x1 Header
Mating Cable Part Number:
6980524
Ethernet Connectors: J17
,
J18
The baseboard hosts two identical on-board connectors for the 10/100/1000 BASE T Ethernet.
The pinouts for the connectors are specified below.
ETH CH. Gnd
A01 B01 Key
DA+
A02 B02
DA-
DB+
A03 B03
DB-
DC+
A04 B04
DC-
DD+
A05 B05
DD-
Connector Type:
2mm Dual-Row Right Angle Pin Header
Mating Cable Part Number
for Latching Connector:
6980604
Mating Cable Part Number
for Pin Header:
6981080
