Elton User Manual Rev 1.04
Page 45
13. GETTING STARTED
This section covers the following topics:
Information about the required components essential to install the hardware to flash the baseboard.
Instructions to configure and setup the baseboard.
Testing instructions to verify and confirm the installation process completed successfully.
Flashing Operating System to AGX Xavier Series Module
NOTE
: The AGX Xavier Series Module must be programmed with the Diamond System Image file for the
interfaces on the Elton baseboard to be operational.
Diamond Systems Image is released as a compressed
tar.gz
file, that can be unzipped on a Linux Host
Machine and flashed on to the AGX Xavier Series Module.
To update the image on the AGX Xavier Series Module, Elton baseboard must be set to Recovery Mode.
This is accomplished by pressing the
RCVRY
(
SW3
) button while powering up the baseboard.
Setting up the Hardware
1. Connect the cable number 6980603 to USB 2.0 port
J3
.
2. Connect the USB A2A cable to the 6980603 cable interface and the other end to the Host PC
USB port.
3. Press the
RCVRY
(
SW2
) button while powering up the baseboard.
Refer to the following image for the display location of the
RCVRY
(
SW2
) button and the cable connections.
Figure 13.1-1: Setup to Initiate Recovery Mode on the Baseboard
