USER’S MANUAL - MOD. “BABY”
PACKAGING
: You should have received your refrigerator with the packing materials intact,
please check that the package is not damaged when it is delivered to you. Before removing the
refrigerator from the packing materials, check that the label FRAGILE is legible and that the arrow
points up. Check that the contents have not been damaged during shipping.
The refrigerators are packed at our facility and are delivered to the shipper undamaged and
properly packaged for transport, therefore we disclaim all responsibility for eventual damages
caused during transport.
Please store the packaging in a dry place; these materials will be necessary for shipping the unit to
the factory in case technical assistance is needed (whether under guarantee or not). Please
remember, however, that all of our packing materials are produced in accordance with regulations
both for packaging materials and for recycling purposes.
INSTALLATION
: After removing the refrigerator from the packaging materials, leave it in an
upright position for at least 30 minutes, making sure that the various basins are correct for your
needs.
Check that the On/Off button is in the OFF position (O). Make sure that the installation area (work
counter) is not exposed to sources of heat, and that the temperature does not exceed 45°C; the
refrigerator should NEVER BE DIRECTLY EXPOSED to the heating rays originating from ovens.
Leave at least 10 cm of air space in the area of the refrigerator air ventilation system so that it can
function correctly and efficiently.
Please be informed that irregular conditions compromise both the operation and the life-time of the
refrigerator you have purchased (please note that incorrect installation of the unit will invalidate the
guarantee).
Once the refrigerator has been installed, plug the cord into an electric system which has been
installed according to government regulations (with a ground fault circuit breaker, a suitable
grounding system, etc.). For further information regarding this, refer to the technical data on the
identification plate on the machine. Please remember that a faulty power source will irreparably
damage some of the components of the refrigerator, and that damages of this type are not covered
by the guarantee.
Avoid any type of modification to, or tampering with the refrigerator system.
The desk-top refrigerator must normally be installed horizontally; it is however possible to raise the
rear part 5 cm for improved access to the inner basins.
NOTE: IT IS IMPORTANT that the basins be properly cleaned before putting ice cream into
them.
START-UP
: Our refrigerators undergo a total of 3 inspections before being sold, therefore they
should be trouble-free; however, if the contrary is true, we truly apologise.
After having correctly installed the unit, proceed with the start-up phase which is as simple as
pushing the green button into the ON position (I), and within 60 seconds the refrigerator will start-
up.
Once the system is operating, a maximum of 4 hours is required for the unit to come up to the
factory set temperature of -18°C. If you would like to change the temperature setting,
simultaneously press the “SET” button for 5 seconds : the SET POINT temperature shows up and
start to flash. Push the “Up Arrow” to raise the temperature, or the “Down Arrow” button to lower
the temperature and press again SET to confirm the change.
Remember that our counter top refrigerators maintain the temperature inside the food bins rather
than lowering the temperature, and therefore the food products should not be placed into the basins
until they have reached the proper temperature.
