background image

 

 

Unpackaging your Refrigerator 

  

To unpackage your refrigerator cut and re-

move all plastic strapping; remove cardboard 
box and edge protectors, then remove plastic bag 
covering refrigerator. 

Caution

, keep plastic bag 

away from children. Dispose of, or recycle 
promptly. Proceed by removing packaging tape 
from all Styrofoam and cardboard corners, and 
remove refrigerator from it’s cardboard/ 
Styrofoam base. Leave tape from doors in place 
until refrigerator is in it’s desired spot. Now 
transport unpackaged refrigerator to site. Note: a 
padded appliance hand truck is great to move 
refrigerator through doors and up or down 
stairways. A padded appliance hand truck can be 
rented from most appliance retail shops. 

Refrigerator Set-up 

  

 

 
 
 
   

 

 
 
 
 

 

 

To set up refrigerator, please follow these 

instructions to their entirety.  

1.

 

Gas Connection. 

 

All 

Diamond

 refrigerators are equipped 

with a 

” male flare hook-up. This connec-

tion is located on the back of the refrigerator 
towards the bottom, left side. This fitting 
does not require the use of any paste, tape, 
or liquid sealers. Use a flex line to connect 
the refrigerator from the gas source that is 
long enough to move the refrigerator away 
from the wall to access the rear for service. 
Be careful not to over tighten the connec-
tion. The fitting needs only to be snug with a 
wrench. Remember to use a backer wrench 

when tightening fitting. (See picture 
above)It is recommended that you install an 
ON/OFF gas valve before the flex line.   

2.

 

Leak Testing 

Prior to lighting your refrigerator, you 

must check for leaks. This is done by mix-

ing some dish soap 

with water and apply-

ing the solution to all 
gas fittings with a 

toothbrush or paint-

brush then turn on 

your gas supply. If 

leaks are present, air 

bubbles will appear. 

Should you find air 
bubbles, shut off gas 

supply and re-tighten 

fitting. Be careful not 

to overtighten the fit-

ting. For more information, watch the Di-
amond Maintenance DVD 

3.

 

Gas Pressure 

     

Diamond

 propane refrigerators are 

designed to operate from an LP gas sup-
ply with a gas pressure of 11” water col-

umn. Have your gas supplier or another 

qualified person check this for you.  

4.

 

Interior Light 
 

Diamond

 refrigerators are equipped 

with LED interior lights. Light may or may 

not be used. If you wish to use the light, in-

sert four AA or D batteries (included) into 
battery holder on back of refrigerator. 

 

 A qualified person should perform 

all gas connections and installations. 

     Propane is flammable. If you 

smell gas, extinguish open flames; 
do not operate electrical switches; 

open windows and promptly call 

your gas supplier. 

 

!

 

Leak Present! 

No Leak 

 

Backer Wrench 

07/12     Version 3.1

Page 4

Summary of Contents for Deluxe 13 cu ft













Reviews: