Lighting
After set-up of refrigerator is complete, you
are ready to light the burner. Lighting the refrig-
erator for the first time will take longer than
usual due to the air in the gas lines.
Before attempting to light the refrigerator, you
will need to determine with which control style
your refrigerator is equipped. The difference is if
your control has a flame indicator or not.
If you have a flame indicator follow instruc-
tion A. If not, follow lighting instructions B.
Lighting Instructions A.
1.)
Remove front grill (See Picture below)
2.)
Turn thermostat knob to position 3
3.)
Turn
ON/ OFF
valve to “ON” position
(horizontal).
4.)
Press in and hold the gas safety button
while pushing the ignitor button repeat-
edly to light the burner.Watch the red
needle on the flame indicator to see if the
flame is lit. When lit, the red needle will
movefrom white to green.
Lighting Instructions B.
1.)
Remove Front grill
2.)
Turn thermostat knob to position 3
3.)
Turn
ON/OFF
valveto “ON” position
(horizontal)
4.)
Press in and hold the gas safety button
while pressing the ignitor button repeat-
edly to light the burner. Watch through
the opening to the left of the thermostat
to locate the flame at the back, left side of
the appliance, approximately five inches
from the floor. (See picture below)
We recommend that upon initial lighting to
take a picture or a good look at the flame and
memorize the size and color for future reference.
It is recommended that you check the color and
size of the flame upon every start-up.
Hand Lighting
If for some reason the refrigerator will not
light with the peizo ignition or the ignitor fails to
spark, it is possible to hand light the burner. To
do this you will need two people and simply use
the above procedure and replace the ignitor but-
ton with a person at the burner with a lighter.
Flame indicator
No Flame indicator
Remove front grille
07/12 Version 3.1
Page 6
