Diamond MP900, User Manual

①

pull out the battery from the rear;   

②

put 2025 battery into the slot, paying attention to the positive and 

    negative electrodes; 

③

make sure the battery lip is on. 

2.

Connection between U6 and television 

2.1 AV connection 

Connect the composite terminal of AV cable (tri-color RCA of red, white and yellow) 
to AV output of U6, correspondingly connect another terminal of AV cable to AV input 
of television. 

2.2 High-definition YUV connection 

Connect the composite terminal of YUV cable (tri-color RCA of green, blue and red) 
to YUV output of U6, correspondingly connect another terminal of YUV cable to 
YUV(YCbCr or YPb/Pr) input of television. In addition, connect with the AV cable as 
above-mentioned 2.1 for audio connection, or connect the AV cable from coaxial 
output of U6 to coaxial input of external amplifier. 

2.3 HDMI and coaxial connection   

      Please refer to the connection diagram 

2.4 Notes: 

①

after connecting the player with the television, make sure a correct   

      connection between the player and television .   

②

when connecting with the television, make sure a correct selection of   

      television signal source, if no image under the right selection,   
      please press the video key on the remote controller to switch    output   
      signals of the product till matching with the television signals.   

③

when your television supports high-definition input, it is   

        recommended to choose "720P or 1080P" mode to watch. 

④

coaxial(SPDIF) connection : connect the yellow terminal to amplifier 

        with AV cable, or connect the blue terminal to amplifier with YUV( the   
    high-definition video signal) cable. 

2.5 Diagram of U6 and the peripheral device