34
1250 E
f
Owner’s Manual
Workout Programs (continued)
Beginning the Program
During idle mode, the message window displays a message “SELECT A PROGRAM”.
To begin this program, press “Cross Training” key until “Glute Burner” program LED
indicator lights up.
Accepting default values or Entering the program setup mode
When the message display flashes, “GLUTE BURNER”, it indicates you are about to
select the Glute Burner program. It then scrolls “PRESS ENTER TO ADJUST OR START
TO BEGIN” and wait for an instruction.
•
Press “Start” key to accept current default values and begin Glute Burner
program workout.
–
Default Time = 30 minutes
–
Default Intensity level = a preset intensity profile with default Intensity
difficulty level = L1.
–
Default Incline level = a preset incline profile with default Incline difficulty
level = L1.
•
Or press “Enter” to enter program setup mode. The message display will take
you through the program setup mode step by step as below: (same as Manual
program setup)
–
Entering Age
–
Entering Weight
–
Entering Time
During the Program
Once Start key is pressed, the Warm Up will be active. See Warm Up mode section for
details.
Display
•
When Warm Up is completed, the message display will turn into workout data
display and display four default data: time, level, calories & pulse.
•
Press “Select” button under each group to select your desired data display.
Adjustment
•
Press “Level Up/Down” key to adjust the intensity difficulty level from L1 to L10.
The dot matrix window will update the intensity profile accordingly.
•
Press “Incline Up/Down” key to adjust the incline difficulty level from L1 to L10.
The dot matrix window will update the incline profile accordingly.
•
Personal Trainer program – Personal Trainer program cannot be active during
Glute Burner program. See Personal Trainer program section for details.
•
HR Lock program – Press “HR Lock” key to switch to target HR program if there
is a valid pulse. See HR Lock program section for details.
Ending the Program
•
When program time is up or Stop key is pressed, this program will end and
Cool Down will be active.
•
The message display will flash a message “PROGRAM END”& “COOL
DOWN”. See Cool Down mode for details.
•
“Start” key could be pressed to re-start the Glute Burner program again.
1250OM-Rev1 9/8/04 2:03 PM Page 34
