ENGLISH
13
5) insert the sleeve of the suction hose (fig. E, ref. 4) fully into the squeegee;
The squeegee blades scrape the film of water and detergent from the floor and prepare
the way for perfect drying. With time, the constant rubbing makes the edge of the blade
in contact with the floor rounded and cracked, reducing the drying efficiency and requiring
it to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear
blade bends during operation by about 45° with resp ect to the floor at every point. Adjust
the height of the blade during operation by regulating the height of the wheels positioned
behind and alongside the squeegee (fig. E ref. 3).
6.3.
Moving the machine when not in operation
To move the machine, proceed as follows:
•
lift the squeegee using the squeegee lever (fig. D, ref. 2);
•
raise the front of the machine by levering on the handle and move it to the destination.
•
on arrival, lower the front of the machine.
6.4.
Mounting and changing the brush/drive disks
IMPORTANT
Never work without the brushes and drive disks correctly installed.
Brush attachment: turn the machine on by pressing the main switch (fig. C, ref. 3) (LED
on), then press the brush button (fig. C, ref. 4 (LED on). Rest the brush on the floor in
front of the machine. Raise the front of the machine by levering on the handle, then lower
it onto the brush, centring it with the brush cover. Operate the brush lever (fig. D, ref. 1)
repeatedly until the brush automatically engages on the flange hub. If the manoeuvre is
not successful, press on the handle again and repeat the centring and repeated operation
of the brush lever.
Brush release: turn the machine on by pressing the main switch (fig. C, ref. 3) (LED on),
then press the brush button (fig. C, ref. 4 (LED on).
Raise the front of the machine by levering on the handle, then operate the brush lever
(fig. D, ref. 1) repeatedly. After a few pulses, the brush (or drive disk) is released and
falls to the ground.
6.5.
Detergents - Instructions
IMPORTANT
Always dilute the detergent according to the manufacturer's instructions. Do not
use sodium hypochlorite (bleach) or other oxidants, particularly in strong
concentrations. Do not use solvents or hydrocarbons. The temperature of the
water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made
specifically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section "Safety
regulations".
