Quick Start
• Select the Samples tab on the Setup screen.
Press the Setup button next to the desired field
you wish to change. Changing these settings
requires the logger to Clear & Restart.
•
WARNING:
Do not change any settings in
the channels section of the Setup. altering
these parameters will cause your logger to operate
improperly.
• The logger is now sampling and ready to use.
Verify that the indicator light is flashing every 10
seconds.
NOTE:
To conserve battery life when storing unit, press
the “Setup” button and select “Stop When Full”.
•
Install the DicksonWare™ Software (ver. 6.0.4.2
or later). Press the “Features” button for features
and detailed operation instructions (Help).
• Connect the cable (supplied with the software)
to the logger and to a working serial port on your
computer. If the port is not COM2, refer to
“Setting Up Your Computer’s Serial Port” in the
“Getting Started” chapter in the DicksonWare™
Help.
• Connect your 0-15 VDC source transmitter(s)
using the channel polarity indicated on front label.
• Press the “Setup” button and make sure software
recognizes the logger (logger will recognize as
ES120).
DICKSON
ES120A
Pro Logger Operation
PRO SERIES
DICKSON
ELECTRONIC SIGNAL DA
TA LOGGER
For Technical Support
: 630•543•3747 • www
.dicksonweb.com
CH1+
CH1-
CH2+
CH2-
