Dickson TH6P Manual V5 052418
1
DICK
DICK
DICK
DICKSON
SON
SON
SON
T
T
T
TH
H
H
H6P1 /
6P1 /
6P1 /
6P1 / TH6
TH6
TH6
TH6P2 /
P2 /
P2 /
P2 / TH6P3
TH6P3
TH6P3
TH6P3
Remote Sensing
Remote Sensing
Remote Sensing
Remote Sensing Temperature
Temperature
Temperature
Temperature/Humidity
/Humidity
/Humidity
/Humidity Recorder
Recorder
Recorder
Recorder
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
7-day chart rotation
0 to 100
o
F (TH6P3)
+32 to 100F (TH6P1/2)
QUICK START
QUICK START
QUICK START
QUICK START
1.
1.
1.
1.
Remove the protective pen caps.
2.
2.
2.
2.
Connect Sensor: TH6P1/2: Make sure the R200 replaceable sensor is connected firmly to
the recorder. TH6P3: Make sure the R250 sensor is connected firmly to the 10’ extension
cable and the extension cable in plugged in firmly to the recorder.
3.
3.
3.
3.
Insert 4AA batteries and plug in AC adapter (See Figure 3). Unit will power on.
4.
4.
4.
4.
The instrument will move pens to the appropriate readings.
5.
5.
5.
5.
Install the chart that matches selected Dip Switch settings (See p.4).
Press the PEN
PEN
PEN
PEN HOME
HOME
HOME
HOME key to move the pens to the outside of the chart. The pens are
automatically raised off the chart.
Remove the old chart, place the new chart on the Chart Hub being certain that the edge
of the chart slides under the Chart Guide Clip located at the outside of the chart.
6.
6.
6.
6.
Set the appropriate time. There are two ways to adjust the chart and set the appropriate
time:
a.
Set the chart time manually by inserting a coin into the groove in the chart hub
and turning clockwise until the correct hour (and day if applicable) on the chart is
referenced to the timing arrow (just to the right of the pens tip on the dial). Press
Pen
Pen
Pen
Pen Home
Home
Home
Home to move the pens back onto the chart.
www.
.com
information@itm.com
1.800.561.8187
