Yog’s E-PIPE one powered by dicodes
14
The display mode switches the dynamic display of various parameters on and off
during and after the pull. With the "cont" (continous) setting, the values are displayed
during and 4 seconds after the pull. With "post" the values are displayed only after
the pull and "off" switches the display off.
The values displayed depend on the operating mode: In temperature controlled
mode, the parameters are temperature, coil resistance, temperature regulating power
and a battery symbol.
For Power, Boost, and Heater Protection modes, the selected power (or limited power,
if applicable), coil resistance, and battery voltage are displayed. When Bypass mode is
selected, the coil resistance and the measured power depending on the battery
voltage are displayed, since there is no fixed power setting in Bypass mode.
The E-PIPE one can be used in 5 different modes. However, to keep the menu as short
and simple as possible, 3 of the 5 modes are only available when Expert mode is set
to 1. The name Expert mode means that the use of the additional operating modes
requires additional knowledge about their functionality.
The additional modes available with Expert Mode set to 1 are "Power Boost", "Heater
Protection" and "Bypass".
Here is an overview of the modes once again:
Mode0
Power
Power-controlled vaping. The set power is delivered to the heating coil, unless the
power is limited by a protective mechanism.
Mode1
Temp-Cont.
The temperature control takes over the power setting and keeps the set temperature
constant. Important to note: Set wire temperature coefficients and adjust at room
temperature (perform reference measurement).
Mode2
Heater-Prot.
The power output is interrupted briefly at regular intervals to allow liquid to flow and
to limit the temperature.
Mode3
Power-Boost
The heating coil is heated up quickly at the beginning with high power. A repeated
boost can additionally be activated during steaming. Important to note:
Do not choose the "boost power" too small. However, you should reduce the normal
power setting significantly, adapted to the vaporizer.
Mode4
Bypass
The device behaves like a mechanical mod, i.e. the battery voltage is switched
through directly to the heating coil. If the resistance of the coil is too low, an error
message is displayed (Err8 LowR). Important to note: The vaping result is now de-
pending on the state of charge of the battery and the coil should not be designed
with too low resistance, otherwise the 20A limit is quickly reached.
