Yog’s E-PIPE one powered by dicodes
5
6.
Product overview
6.1.
General note on the use of the E-PIPE one
The E-PIPE one is able to control a heating coil with up to 60W. At 60W continuous power, all common heating coils
will inevitably become significantly hotter than the maximum steam temperature of 240°C that we recommend. The
user should also keep in mind that taking 60W from even the best "high drain" batteries available on the market will
generate a high power loss of about 10-15W in these batteries themselves as well as in all contact points and
components, which will ultimately reduce the battery life.
We therefore recommend using the E-PIPE one in temperature-controlled mode or in boost mode. In these two
modes, the risk of reaching a too high vapor temperature is minimized. The vapor result, i.e. the taste is even better in
this case, since even with large coils with a large heat capacity, only a small amount of power is required to maintain
the temperature after a quick heat-up phase (at high power).
6.2.
Battery usage instructions
Always use batteries with high to very high current carrying capacity (even at the expense of capacity, unless you are
steaming at powers <20W). Avoid "no-name" products. Always insert the battery into the E-PIPE one with the positive
terminal facing down.
The E-PIPE one is equipped with a self-calibrating touch sensor. After inserting the battery, the sensor will calibrate
itself within the first 15 seconds. Please do not touch the fire button while inserting the battery and within the first 15
seconds after.
6.3.
Removable display
The E-PIPE one has a removable OLED display unit. All important information is optionally displayed here during
(display-mode=cont) and/or for 4 seconds after vaping. If the display unit is removed, vaping with the last set values is
still possible, but the accidental adjustment of values is blocked.
Temperature controlled mode:
Temperature during vape
Other modes: battery symbol
Battery-voltage during
the vape, including voltage
drop.
Wattage setting
In Direct-Mode (Bypass)
it shows the actual power
applied to the coil.
Coil-Resistance during vape,
including temperature
dependent increase.
