3.3.3
Opening the Cencon® System 2000 GEN 2 Electronic Lock
Perform the following procedure to open safes with a Cencon® System 2000
electronic combination lock.
NOTE
If the lock has the remote access feature, a remote signal will be
required to open the lock. Follow the institution's procedures
for the remote access feature.
You must open the safe within
fi
ve seconds after entering the
correct combination. Otherwise, it will relock. To open the
safe, turn the safe handle clockwise until it stops.
1. Spin the dial left, counterclockwise, until the letters
EC
appear on the
display (see Figure 3-6).
2. Enter the lock combination on the electronic lock keypad (refer to the
appropriate lock operating guide listed in Appendix A or your institution's
procedures for information about entering the lock combination).
1
Spin the dial counterclockwise until
EC
appears on the display
2
The letters
EC
appear on the display
Figure 3-6 Entering the Combination on the Cencon® System 2000 GEN 2
3-8
Copyright ©Diebold, Incorporated (9/2014, 3/2016) - All Rights Reserved
Copyright ©Diebold Nixdorf, Inc. (4/2017, 10/2017) - All Rights Reserved
TP-821765-001D