Operation
4.1
4.1
T/SOP
To use T/SOP, press the wrench button on the external control unit (
) and follow the instruc-
tions on the rear service display.
4.1.1
4.1.1
Startup and Shutdown
4.1.1.1
4.1.1.1
Starting up / Shutting down the System
NOTE
The system is switched on and off via the external control unit. A general description of
the external control unit can be found in the chapter External control unit.
NOTE
Depending on the system and variant, the external control unit can be installed at different
positions in the system.
The position of the external control unit can be found in chapter "Description", section
"System overview".
4.1.1.1.1
4.1.1.1.1
Starting up the System
NOTE
After shutting down the system, you must wait at least five minutes before starting up the
system again.
Figure 4-1:
Switching off the System
ü
Gain access to the external control unit (see
chapter “Description”, section "System over-
view").
ü
Make sure the power switch is on.
1.
Press the on/off button on the external con-
trol unit (see chapter External control unit
Overview).
C
The ON/OFF LED lights up green.
C
The system starts.
Copyright © 2021, Diebold Nixdorf
01750337284 C
4-2
