3
4
Important Notes
Terminals supplied by Diebold Nixdorf comply with the respective safety regulations for data-
processing installations and information technology installations, including electrical office
equipment for use within an office environment.
WARNING
Whenever work of any kind is done on the device, as well as when data ca-
bles are plugged and unplugged, the device must be completely discon-
nected from the line voltage.
Terminals may only be installed and repaired by authorized technicians.
•
Unauthorized opening of the housing or inexpert repairs can result not only in considera-
ble personal danger, but will also invalidate your warranty and liability protection.
•
Always consult the enclosed documentation before doing any work with this terminal.
•
If this terminal is brought from a cold environment into a heated place of business, con-
densation may occur. Before operation, the terminal must be completely dry. Therefore,
an acclimatization period of at least two hours must be adhered too.
•
Always lay the supply leads and cables in such a way that they cannot be stepped on or
tripped over.
•
Exchange damaged cables immediately.
•
In order to completely disconnect the terminal from the power source use the separator in
the fuse box\building installation.
•
Make sure that no objects (such as paper clips) can reach the interior of the terminal,
since electrical shocks or short-circuits could result.
•
Ensure that the K-two receives adequate ventilation to avoid overheating.
•
During an electrical storm, data cables should not be plugged in or being unplugged.
•
Keep the terminal away from vibrations, dust, humidity and heat.
•
Ensure that used parts are disposed of in an environmentally friendly manner.
•
In case of an accident (such as a damaged housing, entry of liquids or foreign objects),
switch the terminal off and use the separator to completely remove the terminal from
power.
Summary of Contents for K-two
