Recycling module RM4H
01750306327A
Recycling Module RM4H - Operator manual
79
Releasing banknote rails
Release the rail by pulling up the
horizontal tab (1) at the end of the
banknote rail until the catch is
above the crosspiece. At the same
time push against the lug (2), and
push the rail in the direction of the
cassette handle. Remove the rail
upwards (3).
Inserting banknote rails
First, position the rail on the
dispensing side (2) in the required
locking position (1) with the lug
pushed under the edge of the
pressure carriage.
Then insert the rail on the cassette
handle side so that the required
value is shown on the scale for the
banknote width. Press the rail
downwards in the direction of the
scale and, at the same time, push
it towards the dispensing side (3).
Then push the tab down until it
snaps into place and is positioned
horizontally.
NOTICE
Make sure that both banknote rails are set to the same scale value at all
four positions.
Summary of Contents for RM4H
Page 1: ...Recycling Module RM4H Operator manual...
Page 40: ...Recycling module RM4H 40 Recycling Module RM4H Operator manual 01750306327A...
Page 61: ...Recycling module RM4H 01750306327A Recycling Module RM4H Operator manual 61 Remove the key...
Page 87: ...01750306327A Recycling Module RM4H Operator manual 87 notes notes...
