ENGLISH
- 12 -
•
Dielectric isolation: 2.5 Kv for 60”.
•
Software configuration to control the environment temperature.
•
Resolution 1° C.
•
Working temperature of device from -40°C to 60°C.
•
Max allowed dampness in the room 90% not condensing.
•
Electrical connections with fast polarised connectors.
•
Possibility of manual relays switch through menu test relays to simulate and check
the reliability of contact.
•
Technical manual in three languages (and more on request).
•
Construction in accordance with rules
.
•
Input filter for power supply in accordance with rules
.
•
Tropicalization (optional).
ASSEMBLY
Perform a square hole measuring 91x91 mm, fasten the ME100 V1 through the special
hooks.
POWER SUPPLY
The device can be supplied with (24÷240) Volt AC/DC ± 10% 50/60 Hz without
respect of polarity.
ELECTRICAL CONNECTIONS
Perform the connections on the terminal board following the scheme on TAB1 at the
end of this manual.
FAULT relay usually results excited during normal working of device (FAULT STATUS
A, TAB 1), in case of failure of probes or feeding absence, the relay switch off (FAULT
STATUS B, TAB 1).
FAN relay is dedicated to the management of the fans of cooling of the transformer or
for the conditioning of the environment where the transformer is installed.
The ALARM and PRE AL relays switch on when the temperature is higher than one
degree of set level.
Summary of Contents for ME 100 V3
Page 2: ......
Page 26: ...TAB 1 26 ...
