10
DIETZ GmbH // User manual for TOMTAR VFG // Version 1.0.0 EN
3 PREPARING THE QUAD CANE FOR USE
ASSEMBLY INSTRUCTIONS
The TOMTAR VFG quad cane is supplied in two
parts (push handle & frame).
3.1 Assembling the quad cane
1.
If necessary, loosen the thread of the bushing
by turning it anticlockwise (1, Fig. 1). Do not
unscrew the top part of the bushing com
-
pletely. Simply loosen the connection.
2.
Hold the black push handle at the bottom,
where the two spring pins are located.
3.
Press in both spring pins (2, Fig. 1). At the
same time, insert the push handle into the
frame at the top of the bushing (3, Fig. 1).
4.
Keep inserting the push handle until the
spring pins pop out through the holes.
5.
The spring pins must make a clearly audibly
noise as they click into place. The spring pins
should now be noticeably protruding from the
holes (1, Fig. 2).
6.
Tighten the thread of the bushing by turning
it clockwise (2, Fig. 2).
7.
Your quad cane is now fully assembled.
3
2
2
Abb. 1
1
Abb. 2
2
1
WARNING
Danger of crushing!
Be careful of your fin
-
gers when tightening the bushing.