10
Measuring Temperatures
1. Plug the thermocouple into the T1 input connector.
Make sure that the polarity is correct.
2. Press
power on/off
button to turn on the thermometer.
After one second the thermometer displays the first
reading. If no thermocouple is plugged into the
selected input or the thermocouple is not connected
properly, the display shows "- - - -". If the temperature
being measured is outside the thermocouple’s valid
range, the display shows “OL” (overload).
3. Set the thermometer for the correct thermocouple
type (K or J) in Setup menu.
4. Press
°C/°F/K
button to select the desired
temperature scale.
Hold Function
1. Press
/Hold
button to freeze the readings on the
display. The display shows the
HOLD
icon.
2. Press
/Hold
button again to turn off the Hold
function.
Min/Max/Avg Function
1. Press
Max/Min/
button to step through the
maximum (MAX), minimum (MIN), and average
(AVG) readings. The elapsed time since entering
Max/Min mode, or the time at which the maximum
or minimum reading occurred, appears on the
display.
2. Press and hold
Max/Min/
button for 3 seconds
to exit Max/Min mode.