5
Operating Mode Settings
Data logger has two operational settings
from which to choose: “Datalogger”
operation or “Real-time” operation.
“Datalogger” Operating Mode:
Allows you to set up the logger for remote
temperature and humidity logging with the
user selectable settings as shown below:
Manual Start Mode:
lets you remove the
logger from the computer USB port once
the settings are programmed and move it to
the location of interest without it starting.
Operation is initiated manually by pressing
the Start button on the housing for 3 sec-
onds until the green LED lights up.
Instant Start Mode:
allows the logger to
begin recording automatically once it is
removed from the computer USB port.
Sample Rate
: set rate from 2 seconds to
24 hours between data samples.
Max Points:
select the number of samples
up to 32,000 (16,000 per channel).
Record Time:
calculates the run time based
on sample rate and max points selected.
LED flash cycle:
increase the flash cycle to
conserve battery life. (See "LED Status
Guide" on page 3.)
Enable high and low alarm:
click to access
the Temperature and Humidity (RH models
only) settings. Program both the high and
low alarm limits. (See "LED Status Guide"
on page 3 to identify alarm conditions.)
Temperature Unit:
choose either Fahrenheit
or Celcius to log and display temeperatures.
Humidity Unit (RH models only):
preset as
%RH.
➞
➞
www.
.com
information@itm.com
1.800.561.8187
