Digi-Sense 20250-53, User Manual

9

9.  To return to normal operation, press and hold the 

PEAK 

button until the “Pmax” or “Pmin” indicator switches 

off.

10.  If the rotary function switch position is changed after a 

calibration, the PEAK Hold calibration must be repeated 

for the new function selected.

BACKLIGHT Button
1.  Press the BACKLIGHT button to switch on the display 

light.

2. Press BACKLIGHT button again to exit the light mode.

AC and DC Voltage Measurements 

1.  Insert the black test lead into the negative COM terminal 

and the red test lead into the positive V terminal.

2. Set the rotary function switch to the V AC/DC position. 
3.  Press the MODE button to select “AC” or “DC” voltage. 
4. Connect the test leads in parallel to the circuit under test.
5. Read the voltage measurement on the display.

AC and DC Current Measurements
1.  Insert the black test lead banana plug into the negative 

COM jack.

2.  For current measurements up to 4000 µA, set the rotary 

function switch to the µA position and insert the red test 

lead banana plug into the (µA, mA) jack.

3.  For current measurements up to 400 mA, set the rotary 

function switch to the mA range and insert the red test 

lead banana plug into the (µA, mA) jack.

1065DGMAN_20250-53-54 Manual.indd   9

8/16/2017   10:42:05 AM