- 9 -
Battery level indicator
If the battery charge is too low to power the radio controlled weather station, the sensors
and data transmission, the battery level indicator
13
or
18
will appear on the
display. The batteries should be replaced in all devices as soon as possible. Restart the
weather station.
Channel setting for sensors 1-3
Your radio-controlled weather station can be used with up to 3 sensors at the same time.
Open the battery compartments of the sensors
41
and set the channel (1, 2, 3) you wish
to use for each sensor using the channel selection switches
40
. The radio-controlled
weather station will now receive the signals from the sensors 1-3 and the signal reception
symbol
17
will appear on the display of the radio-controlled weather station. To
manually transmit the measured data from the sensor to the radio-controlled weather
station, press the TX-button
43
. Press the °C/°F button
42
to select the temperature unit
°C-Celsius and °F-Fahrenheit. Close the battery compartment
41
.
! Note: The sensors must be set up within a maximum of 100m from the
weather station with no obstacles.
Naming the sensors
The sensors can be placed in different rooms or outdoors. It is possible to assign a name
to each sensor on the radio controlled weather station at
16
. For example, a sensor
placed in the bathroom could be named BATH. When setting the names it is possible to
select one of the pre-set names: BATH, BEDRM, KID1, KID2, YARD. It is also possible to
enter custom names with up to 5 characters each.
Setting pre-set names
\
Room 1
Room 2
Room 3
Room 4
Room 5
DE
BAD
BETT
KIND1
KIND2
GARTN
GB
BATH
BEDRM
KID1
KID2
YARD
FR
BAIN
SOMML
ENF1
ENF2
JARDN
IT
BAGNO
SONNO
BAMB1
BAMB2
GIARD
ES
BANO
DORMI
NINO1
NINO2
JARDN
DK
BADEV
SOEVN
BARN1
BARN2
HAVE
SE
BADRM
SOEMN
BARN1
BARN2
TRADG
To select a name for sensor 1, press the
1-ROOM
-button
30
. Press the
1-ROOM
-button
30
again to view the different pre-set names. If you wish to select one of the names, wait
for 5 seconds until the selected name no longer blinks. The name is now set. Select the
names for the other rooms in the same way.
Setting custom names
Custom names can also be set for the sensors. Up to 5 custom names can be set. When a
sixth name is set, the first stored name will by overwritten automatically. To set a custom
name, the letters A-Z, the special characters
, , , , , , , and the numbers 0-
9 are available.
To set a custom name for Sensor 1, please proceed as follows: Press the
1-ROOM
-
button
30
and then immediately press the
up
-button
25
. Press the
up
-button
25
or
the
dow
n-button
26
to select a character. When the desired character appears, press
the
1-ROOM
-button
30
to confirm your setting and move to the next character of 5
possible characters in the name. It is possible to delete characters by pressing the
SET
-
button
32
. Once 5 characters have been entered the display will automatically return to
normal time display mode. If you have entered less than 5 characters, press the
1-
ROOM
-button
30
2x to return to normal time display mode. Set the names for sensors 2
and 3 in the same way.
