Configure the AnywhereUSB Plus Hub from the CLI
set service
AnywhereUSB® Plus User Guide
144
set service
Purpose
Used to:
n
Enable and disable network services.
n
Change the network port on which a given service listens.
n
Display the entire service table, or an entry in the service table.
Syntax
Enable/disable network services or change network port for service
set service [range=
range]
[state={on|off}]
[ipport=
network_port]
Display service table or entries in the table
set service [range=
range]
Options
range=
range
Used to specify the index of the network service to which the rest of the command’s options apply.
This range varies among Digi devices. Enter
set service
to display the index numbers for the network
services on your Digi device.
state={on|off}
Used to enable or disable a given network service.
ipport=
network port
Used to change the network port on which a given network service listens.
Supported network services
The following table shows the network services controlled by the
set services
command and the
services provided.
The following types of network services are available:
Service
Services Provided
HTTP
Hypertext Transfer Protocol, also known as Web Server. Provides
access to web pages for configuration that are secured by
requiring a user login. A user login is required for AnywhereUSB
Plus Hubs.
