Regulatory information and certifications
United States FCC
ConnectCore® 8X System-on-Module Hardware Reference Manual
109
The following table shows the antenna that was used to certify the ConnectCore 8X wireless module.
This antenna can be replaced by others, however further certification testing is required. The number
of tests to be carried out can be decreased by using an antenna of the same type, i.e. dualband
omnidirectional dipole, showing lower peak gain. In such case, only a spot check may be required by
the certification laboratories to keep current certifications valid according to FCC regulations. If
replacing by an antenna with higher gain, complete radiated tests according to FCC regulations are
required by the certification laboratories.
Antenna used to certify the ConnectCore 8X wireless module
Antenna
type
Supplier
Antenna part no.
Freq. (MHz)
Peak antenna
gain (dBi)
Directional
gain (dBi)
PCB
YAGEO
ANTX100P001B24553
2402~2480
4.6
7.61
5150~5250
4.9
7.91
5250~5350
3.9
6.91
5470~5725
5.1
8.11
5725~5850
5.1
8.11
PCB
TAOGLAS
FXP830.07.0100C
2402~2480
3.32
6.33
5150~5250
6.11
9.12
5250~5350
6.11
9.12
5470~5725
6.11
9.12
5725~5850
6.11
9.12
Dipole
TAOGLAS
GW.48.A151
2402~2480
3.42
6.43
5150~5250
4.56
7.57
5250~5350
4.56
7.57
5470~5725
4.56
7.57
5725~5850
4.56
7.57
PCB
TAOGLAS
FXP522.A.07.A.001
2402~2480
3.78 (Port 1)
3.15 (Port 2)
6.79
5150~5250
4.63 (Port 1)
4.61 (Port 2)
7.64
5250~5350
4.63 (Port 1)
4.61 (Port 2)
7.64
5470~5725
4.63 (Port 1)
4.61 (Port 2)
7.64
5725~5850
4.63 (Port 1)
4.61 (Port 2)
7.64
