MIL-3000FTX Series of FastPort Print Servers
10-7
-->
Preferred DS Context
: Sets the “context” where FastPort’s server/
queues are defined. The name entered must be a valid “Tree” or “Context.
The field is blank by default.
•
Print Server Config
.-->
Queue Scan Rate
: Sets the rate (times per second) that
FastPort scans the Novell queue for print jobs (valid numbers are between 1-
6). Default:
1
.
-->
Frame Type
: Selects NetWare’s frame type. Default:
Autosensing
.
-->
Configuration Server
: Is the server where FastPort’s bindery
configuration file resides. The field blank by default.
-->
Notification
: Enabling this parameter allows FastPort to send status to
users on the Notify list Default:
Disabled
.
10.4.3General Config.
There are a series of choices that can be selected to configure FastPort for a
general network, including:
•
Community Strings
:
Sets SNMP community strings
. Default for “Get Community
String” is
public
. Default for “Set Community String” is
private
.
•
Flash Config.
-->
Allow download
: Allow/disallow the upgrade of the Firmware. Default:
Allow
.
10.4.4Ethertalk Config.
There are a series of choices that can be select to configure FastPort for a
Ethertalk network, including:
Figure 10-11. Ethertalk Config. Selections
From Ethertalk Config., selections include:
•
General Config
.-->
Zone Name
: Logical group where FastPort exists.
-->
Enable Ethertalk
: Enables/disables the Ethertalk protocol. Default:
Disabled
.
-->
Ethertalk Phase
: Sets the compatibility level of the Appletalk network
system. Default:
Phase 2
.
•
Parallel Printer Setup
-->
Printer 1
: This selection sets printer 1 port’s parameters.
-->
Printer 2
(optional): Sets printer 2 port’s parameters.
-->
Printer 3
(optional): Sets printer 3 port’s parameters.
Note:
The number of printers to configure depends on the number of parallel ports on the
FastPort.
