MIL-3000FTX Series of FastPort Print Servers
8-5
•
Save Maps On Exit
: If this parameter is selected, the software saves
the Map when Discovery Application is exited. Checked by default.
•
Save Parameters On Exit
: If selected, this option saves preferences
when Discovery is exited. Checked by default.
•
Refresh every
: This selection “refreshes” the Map every
<n>
seconds. Default:
60
seconds.
•
Discover
: This selection “re-discovers” hosts every
<n>
seconds.
Default:
90
seconds.
•
Dead
: This selection is the number of attempts the software makes
before marking the node as “dead.” Default:
2
.
•
Wait
: This selection signifies the amount of time the software waits for
a reply from a node. Default:
1
second.
•
Default Map
: This selection will enter the name of the default Map
file:
map.map
.
•
Map File
: This selection will enter the path for the Map files. Default:
c:\fm
.
•
Hosts File
: This selection enters the path for the host file. Default:
C:\ETC
.
•
Bootptab File Path
: This selection enters the path for the bootptab
file. Default:
C:\FM
.
•
Allow To Edit “Hosts” File
: If selected, Discovery updates the
“hosts” file if a new host file is discovered. Checked by default.
•
Default
: Initialize all the parameters to default values.
•
Save Options
: Saves all changes to the
issnmp.ini
file.
•
Cancel
: Cancels the changes.
8.2.2.2Discovery Parameters
The “Discovery Parameters” menu (Figure 8-4) configures the parameters
used for the discovery nodes (Chapter 9). The following section gives
information about the discovery.
•
Enable IP
: When selected, this enables IP protocol. If not selected,
FastManage will not perform any SNMP over IP operation. Checked by
default.
