MIL-3000FTX Series of FastPort Print Servers
9-7
Figure 9-5. Node Properties
To view this menu from the pull-down menu, select
Show node
properties
from the
Window
pull-down menu.
• To change a nodes name:
a. Click once on the desired node. The line is highlighted and the
current name appears on the right-hand side of the screen. Unless
given a name,
UNKNOWN
is displayed.
b. Enter a name into the box. The new name now appears in the node
property field.
• To make a device invisible, deselect the
Visible
box. Again, located on
the right-hand side of the menu.
• Click on
Show Traps
to display traps for a device. For this function to
work on this parameter, your system must be designated to receive
trap. See Chapter 10 for more information on Traps (page 10-4).
Click
OK
when you are finished.
9.4.10SNMP Fault Trace
From the
Window
menu, select
SNMP Fault Trace
to be “On” or “Off”
(default). There are times when an SNMP session cannot be opened
because of a variety of errors. When this happens, an error message
appears. With this option selected, the software counts the times that error
occurred “without” displaying the error message. The number of times the
error occurred is displayed on the status bar (Figure 9-6).
