Digi Rabbit Smartcat BL2100 Series, User Manual

14

Smartcat (BL2100)

2.2  Installing Dynamic C

If you have not yet installed Dynamic C version 7.06 (or a later version), do so now by 
inserting the Dynamic C CD in your PC’s CD-ROM drive. The CD will auto-install unless 
you have disabled auto-install on your PC.

If the CD does not auto-install, click 

Start > Run

 from the Windows 

Start

 button and 

browse for the Dynamic C 

setup.exe

 file on your CD drive. Click 

OK

 to begin the 

installation once you have selected the 

setup.exe

 file.

The installation program will guide you through the installation process. Most steps of the 
process are self-explanatory.

Dynamic C uses a COM (serial) port to communicate with the target development system. 
The installation allows you to choose the COM port that will be used. The default selec-
tion is COM1. You may select any available port for Dynamic C’s use. If you are not cer-
tain which port is available, select COM1. This selection can be changed later within 
Dynamic C.

Once your installation is complete, you will have up to three icons on your PC desktop. 
One icon is for Dynamic C, one opens the documentation menu, and the third is for the 
Rabbit Field Utility, a tool used to download precompiled software to a target system.

If you have purchased the optional Dynamic C Rabbit Embedded Security Pack, install it 
after installing Dynamic C. You must install the Rabbit Embedded Security Pack in the 
same directory where Dynamic C was installed.

The 

Dynamic C User’s Manual

 provides detailed instructions for the installation of 

Dynamic C and any future upgrades.

NOTE:

If you have an earlier version of Dynamic C already installed, the default installation 

of the later version will be in a different folder, and a separate icon will appear on your desk-
top.