Hotspot
Hotspot configuration
LR54 User Guide
352
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure the hotspot to use RADIUS users authentication
RADIUS users authentication requires each hotspot user to enter a username and password. Users are
created on an external RADIUS server, and the username and password is validated by the external
RADIUS server.
By default, the router redirects unauthenticated users to the HTML authentication page located on the
router at
etc/config/hotspot/login.html
. You can customize the authentication page as needed, or
host an authentication page on a remote server. See
Customize the hotspot login page
for further
information.
Required configuration items
n
or
Enable hotspot using the default configuration
n
Select RADIUS users authentication.
n
IP address or hostname of the primary RADIUS server.
n
Users configured on the RADIUS server.
n
RADIUS server secret.
n
RADIUS NAS ID.
n
Domain name or subnet of the RADIUS server included in the "white list" of servers that
unauthenticated hotspot clients can access.
Additional configuration items
n
IP address or hostname of the secondary RADIUS server to be used if the primary
RADIUS server is unreachable.
n
Modify the local HTML authentication page,
/etc/config/hotspot/login.html
, or enter the
name of an alternative HTML authentication page stored in the same directory, or identify a
remote web server to host the HTML authentication page and include that server in the "white
list" of servers that unauthenticated hotspot clients can access. See
for further information.
Hotspot LAN configuration:
Configure hotspot for RADIUS users authentication from the WebUI
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
