Get started
Set up the devices
XBee 868LP RF Modules User Guide
37
DL: SL
of XBEE_B (Enter the last eight characters of the MAC address for XBEE_B. Or select
XBEE_B and find its
SL
value.)
NI:
XBEE_A
4. Click the
Write radio settings
button
.
Set up the second XBee device (XBEE_B)
1. Configure the following parameters:
ID:
2015
DH:
0013A200
DL: SL
of XBEE_A (Enter the last eight characters of the MAC address for XBEE_A. Or select
XBEE_A and find its
SL
value.)
NI:
XBEE_B
2. Click the
Write radio settings
button
.
After you write the radio settings for the XBee devices, their names appear in the
Radio Modules
area.
For more information about the parameters, see the following table:
Parameter XBEE_A
XBEE_B
Effect
ID
2015
2015
Defines the network that a device will attach to. This must be
the same for all devices in your network.
DH
0013A200 0013A200 Defines the destination address (high part) for the message.
DL
SL
of
XBEE_B
SL
of
XBEE_A
Defines the destination address (low part) for the message.
The value of this setting is the Serial Number Low (
SL
) of the
other XBee device.
NI
XBEE_A
XBEE_B
Defines the node identifier.
Note
The default
NI
value is a blank space. Delete the space
when you change the value.
Check the network
Once both XBee 868LP RF Modules are configured, use XCTU to check that they are in the same
network and can see each other.
