Get started
Set up the devices
XBee 868LP RF Modules User Guide
41
c. Make sure the loopback jumper is connected to XBEE_B. See
d. In the XBEE_A console, click
to clear your previous conversation with XBEE_B.
e. Type "Are you out of range?" In the illustration below, the message does not loop back,
which means XBEE_B did not receive it and it is out of range of XBEE_A.
f. If the message loops back, move XBEE_B farther away until it no longer loops back.
2. Add and configure another XBee module:
a. Connect another XBee module to your computer.
b. Click the
Configuration working modes
button
.
c. Click the
Add a radio module
button
.
d. In the
Add a radio module
dialog, select the USB Serial Port for this XBee module and
click
Finish
.
e. Configure this XBee module as follows:
ID
: 2015
NI
: XBEE_C
